Tsymo Pet Feeder Manual Pdf (2024)

FAQs

How do I connect my Wi-Fi to my pet feeder? ›

From the app homepage, click “Add Device.” 2. Select “Pet Feeder.” 3. Select your Wi-Fi® network and enter your router password. NOTE: If the Link Indicator does not blink, press and hold the SET Button for five (5) seconds to reset the Pet Feeder.

Reset the feeder to factory settings, holding down the Add Pet ( ) button for 10 seconds (until the light starts alternating red / green and the lid opens and closes).

Check your home's wireless router and internet are working properly and your phone or computer is connected. If the router or internet is not working, try resetting the router or contact your internet provider. Power cycle the feeder by turning off the power switch. Wait 10 seconds and turn the power switch back on.

Press and hold the Up button and the Down button for three seconds to reset the feeder to factory settings.

Push the WPS button on the router.

In the device's WiFi settings, locate and select the name of the wireless network (SSID) you're trying to connect to. It should complete the connection without entering a password.

Right-click Start and select Settings. Select Network & Internet. Select Wi-Fi/Status and click Change adapter options. Right-click Wireless Network Connection and select Enable.

On the front of the Smart Pet Feeder, you will find the 'feed' button. Press the 'feed' button for 5 seconds. When you hear a beep after about 5 seconds, this indicates that the reset has been performed successfully and the Smart Pet Feeder has been reset to factory settings.

Change time in increments of 15 minutes each week for four weeks. In week one instead of feeding at 5am/5pm provide a dog treat and go for a walk. Then feed at 5:15. The above chart is an example of how to gradually change your dog's feeding schedule.

Why is my PetSafe feeder blinking blue? ›

Yellow Blinking Feeder has power and is in setup mode. Yellow Solid Smartphone is connected to the feeder in setup mode. Blue Blinking Slow Feeder is connected to Wi-Fi but no internet. Blue Blinking Fast Feeder is trying to connect to Wi-Fi or is offline.

Go the pet feeder' settings page, look for “remove device” Remove it and reset the pet feeder and pair it again through the app.

Orange light flashing and lid will not open or close.

Feeder may have been accidentally set to training mode. Push the training fuction button 5 times, pausing between each push to allow the orange light to flash and lid to gradually close.

The Smart Pet Feeder can be reset by pressing and holding the 'feed' button for 5 seconds until a sound is heard. A reset will erase all settings and data on the Smart Pet Feeder and return it to its original factory settings.

THE FUNCTION DESCRIPTION Feed button: Short press to eat one, long press for 5 seconds to restore the factory settings.

The device has a lithium battery. If you do not need to use the device for an extended period of time, you must turn the device off yourself. At the same time, hold down the bowl reset button together with the manual food dispenser button for 5 seconds.